EUROBUL ENGINEERING Ltd.

SIMGRIP® The SimGrip® system is one of the smallest couplers produced by Bar-us. SimGrip® system utilizes internally-threaded couplers with a single right hand thread, and it’s suitable for applications where the continuation bar can be rotated. The ends of the bars are enlarged and a parallel thread is cut onto the ends to suit the threaded coupler. The coupler is assembled using a pipe or chain wrench. Calibrated wrenches are not necessary. Screw the coupler to the rear of the thread, right on the fixed bar. Lock tight. The bar end should be central within the coupler. Remove the plastic cap from the coupler. Position and rotate the continuation bar in the coupler. Rotate the coupler from the continuation bar to engage against the rear of the thread on the opposing bar. Then lock tight. Tighten the joint using a wrench on the continuation bar. After tightening, there should be no more than 2 - 4mm of thread exposed, depending on the diameter of the rebar.